ITech IT8800 Series Programming Guide

Essential Commands
Copyright © ITECH Electronic Co., Ltd. 27
Query Syntax
STATus:OPERation:ENABle?
Returned Parameters
<NR1> (register value)
Related Parameters
STAT:OPER?
STATus:OPERation:CONDition?
This query returns the value of operation condition register. That is a read-only
register that holds the real-time (unlatched) operational status of the electronic
load.
Query Syntax
STATus:OPERation:CONDition?
Parameters
None
Examples
STAT:OPER:COND?
Returned Parameters
<NR1> (register value)
Related Commands
STAT:QUES:COND?
STATus:PRESet
After executing this command, SCPI event register will get the following
affection: All the bits of below register will be cleared：
 Quest event enable register
 Operation event enable register
Note that the register not list above will not be affected by the command.
Command Syntax
STATus:PRESet
Parameters
None
Examples
STAT:PRES

ITech IT8800 Series Specifications

General

Brand	ITech
Model	IT8800 Series
Category	Test Equipment
Language	English