ITech IT8800 Series Programming Guide

Source Subsystem
Copyright © ITECH Electronic Co., Ltd. 54
Parameters MINimum through MAX | MINimum | MAXimum |
DEFault
Unit W (power)
*RST Value MINinum
Examples POW 5 POW:LEV 3.5
Query Syntax [SOURce:]POWer[:LEVel][:IMMediate]? [ MINimum |
MAXimum | DEFault ]
Returned Parameters <NR3>
Related Commands POW:RANG
[SOURce:]POWer:RANGe
This command sets the power range of the electronic load module.
Command Syntax [SOURce:] POWer:RANGe <NRf+>
Parameters MINimum through MAX | MINimum | MAXimum |
DEFault
Unit W (power)
*RST Value MAXimum (high range)
Examples POW:RANG 15 SOUR:POW:RANGE MIN
Query Syntax [SOURce:]POWer:RANGe? [ MINimum | MAXimum |
DEFault ]
Returned Parameters <NR3>
[SOURce:]POWer:TRANsient:MODE
This command selects the operating mode of the transient generator as follows
in constant current mode.
CONTinuous The transient generator puts out a continuous pulse stream
after receipt of a trigger.
PULSe The transient generator puts out a single pulse upon receipt of
a trigger.
TOGGle The transient generator toggles between two levels upon
receipt of a trigger.
Command Syntax [SOURce:] POWer:TRANsient:MODE <mode>
Parameters CONTinuous | PULSe | TOGGle
*RST Value CONTinuous
Examples POW:TRAN:MODE TOGG
Query Syntax [SOURce:] POWer:TRANsient:MODE?
Returned Parameters <CRD>
Related Commands POW:TRAN:ALEV TRAN
[SOURce:]POWer:TRANsient:ALEVel
[SOURce:]POWer:TRANsient:BLEVel
This command specifies the transient level of the input power. The transient
function switches between the level a and level b.
Command Syntax [SOURce:] POWer:TRANsient:ALEVel <NRf+>
[SOURce:] POWer:TRANsient:BLEVel <NRf+>
Parameters 0 through MAX | MINimum | MAXimum | DEFault
Unit W (power)

ITech IT8800 Series Specifications

General

Brand	ITech
Model	IT8800 Series
Category	Test Equipment
Language	English