ITech IT8800 Series Programming Guide

Source Subsystem
Copyright © ITECH Electronic Co., Ltd. 48
Examples CURR:TRAN:AWID 0.001 CURR:TRAN:BLEV 0.02
Query Syntax [SOURce:]CURRent:TRANsient:AWIDth?
[ MINimum | MAXimum | DEFault ]
[SOURce:]CURRent:TRANsient:BWIDth?
[ MINimum | MAXimum | DEFault ]
Returned Parameters <NR3>
Related Commands CURR
[SOURce:]CURRent:HIGH
[SOURce:]CURRent:LOW
This command sets the high and low level of the voltage when in constant
current mode.
Command Syntax [SOURce:]CURRent:HIGH <NRf+>
[SOURce:]CURRent:LOW <NRf+>
Parameters MINimum through MAX | MINimum | MAXimum |
DEFault
Unit V (volts)
*RST Value MAXimum
Examples CURR:HIGH 5
Query Syntax [SOURce:]CURRent:HIGH?
[MINimum|MAXimum|DEFault ]
[SOURce:]CURRent:LOW?
[MINimum|MAXimum|DEFault ]
Returned Parameters <NR3>
[SOURce:]VOLTage
This command sets the voltage that the load will regulate when operating in
constant voltage mode.
Command Syntax [SOURce:]VOLTage[:LEVel][:IMMediate] <NRf+>
Parameters MINimum through MAX | MINimum | MAXimum |
DEFault
Unit V (volts)
*RST Value MAXimum
Examples VOLT 5
Query Syntax [SOURce:]VOLTage[:LEVel][:IMMediate]?
[ MINimum | MAXimum | DEFault ]
Returned Parameters <NR3>
Related Commands VOLT:RANG
[SOURce:]VOLTage:RANGe
This command sets the voltage range of the electronic load module. There are
only one voltage ranges.
Command Syntax [SOURce:]VOLTage:RANGe <NRf+>
Parameters MINimum through MAX | MINimum | MAXimum |
DEFault
Unit V (volts)
*RST Value MAXimum

ITech IT8800 Series Specifications

General

Brand	ITech
Model	IT8800 Series
Category	Test Equipment
Language	English