ITech IT8800 Series Programming Guide

Source Subsystem
Copyright © ITECH Electronic Co., Ltd. 43
Query Syntax [SOURce:]INPut:TIMer:DELay? [ MINimum |
MAXimum | DEFault ]
Returned Parameters <NR3>
Related Commands INP:TIM
[SOURce:]REMote:SENSe
This command is used to select the remote measure state of the electronic
load.
Command Syntax [SOURce:]REMote:SENSe[:STATe] <BOOL>
Parameters 0 | 1 | OFF | ON
*RST Value 0
Examples REM:SENS 0
Query Syntax [SOURce:] REMote:SENSe [:STATe]?
Returned Parameters <CRD>
[SOURce:]FUNCtion
These equivalent commands select the input regulation mode of the electronic
load.
CURRent constant current mode
RESistance constant resistance mode
VOLTage constant voltage mode
POWer constant power mode
Command Syntax [SOURce:]FUNCtion <function>
Parameters CURRent | RESistance | VOLTage | POWer |
*RST Value CURRent
Examples FUNC RES
Query Syntax [SOURce:]FUNCtion?
Returned Parameters <CRD>
[SOURce:]FUNCtion:MODE
This command determines whether the input regulation mode is controlled by
values in a list or by the command FUNCtion settings.
FIXed The regulation mode is determined by the FUNCtion or MODE
command.
LIST The regulation mode is determined by the active list.
Command Syntax [SOURce:]FUNCtion:MODE <mode>
Parameters FIXed | LIST
*RST Value FIXed
Examples FUNC:MODE FIX
Query Syntax [SOURce:]FUNCtion:MODE?
Returned Parameters <CRD>
Related Commands FUNC
[SOURce:]TRANsient
This command turns the transient generator on or off.
Command Syntax [SOURce:]TRANsient[:STATe] <bool>
Parameters 0 | 1 | OFF | ON
*RST Value OFF

ITech IT8800 Series Specifications

General

Brand	ITech
Model	IT8800 Series
Category	Test Equipment
Language	English