ITech IT8800 Series Programming Guide

Trace Subsystem
Copyright © ITECH Electronic Co., Ltd. 40
Returned Parameters <CRD>
Related Commands TRAC:POIN
TRACe:FEED:CONTrol
This command is used to select the buffer control. With NEVer selected,
storage into the buffer is disabled. When NEXT is selected, the storage process
starts, fills the buffer and then stops. The buffer size is specified by the :POINts
command.
Command Syntax TRACe:FEED:CONTrol <CRD>
Parameters NEVer | NEXT
*RST Value NEVer
Examples TRAC:FEED:CONT NEXT
Query Syntax TRACe:FEED:CONT?
Returned Parameters <CRD>
Related Commands TRAC:FEED
TRACe:DATA?
When this command is sent and the electronic load is addressed to talk, all the
readings stored in the buffer are sent to the computer.
Query Syntax TRACe:DATA?
Returned Parameters {<NR3>}
TRACe:FILTer
This command is used to select whether the data in cache is the data filtered.
Command Syntax TRACe:FILTer[:STATe] <BOOL>
Parameters 0 | 1 | ON | OFF
*RST Value OFF
Examples TRAC:FILT 1
Query Syntax TRACe:FILTer[:STATe]?
Returned Parameters <NR1>
TRACe:DELay
This command is used to select the delay time for the trigger in cache.
Command Syntax TRACe:DELay <NRf>
Parameters 0 to 3600s | MINimum | MAXimum | DEFault
UNIT S (second)
*RST Value 0
Examples TRAC:DEL 1
Query Syntax TRACe:DELay? [MINimum | MAXimum | DEFault]
Returned Parameters <NR3>
TRACe:TIMer
This command is used to select the interval of the cache.
Command Syntax TRACe:TIMer <NRf>
Parameters 0.00002 to 3600s | MINimum | MAXimum | DEFault
UNIT S (second)
*RST Value 1

ITech IT8800 Series Specifications

General

Brand	ITech
Model	IT8800 Series
Category	Test Equipment
Language	English