25
4
4
Safety features of your vehicle ISOFIX anchorage and top-tether anchorage (ISOFIX
Anchorage System) for children
Operation
僅 Route the Child Restraint System seat
strap over the seatback.
僅 Connect the top-tether to the top
-
tether anchorage.
僅 Tighten the top-tether according to
the instructions of your Child
Restraint System's manufacturer.
Take the following precautions when
installing the top-tether:
僅 Read and follow all installation
instructions provided with your Child
Restraint System.
僅 NEVER attach more than one Child
Restraint System to a single ISOFIX
top-tether anchorage. This could
cause the anchorage or attachment to
come loose or break.
僅 Do not attach the top-tether to any
-
thing other than the correct top-tether
anchorage. It may not work properly if
attached to something else.
僅 Child restraint anchorages are
designed to withstand only those
loads imposed by correctly fitted child
restraints. Under no circumstances
are they to be used for adult seat
belts, harnesses, or for attaching
other items or equipment to the vehi
-
cle.
Securing a Child Restraint System
with a lap/shoulder belt
Operation
僅 Place the Child Restraint System on a
rear seat and route the lap/shoulder
belt around or through the Child
Restraint System.
僅 Fasten the lap/shoulder belt latch into
the buckle.
僅 Remove as much slack from the belt
as possible by pushing down on the
Child Restraint System while feeding
the shoulder belt back into the retrac
-
tor.
僅 Push and pull on the Child Restraint
System to confirm that the seat belt is
holding it firmly in place.
僅 If your Child Restraint System manu
-
facturer recommends the use of a
top-tether with the lap/shoulder belt,
see Securing a child restraint system
seat with the "top-tether anchorage"
system section in this chapter.
僅 To remove the Child Restraint System,
press the release button on the
buckle, and then pull the lap/shoulder
belt out of the Child Restraint System
and allow the seat belt to retract fully.
To Next Page
Loading...
Need help?
General
