29
7
7
What to do in an emergency If you have a flat tyre (with Tyre Mobility Kit)
may flow backward, possibly clog
-
ging the filling hose.
9. Connect between compressor and
the vehicle power outlet using the
cable and connectors.
Only use the front passenger side
power outlet.
10. With the ignition switched on or
engine start/stop button position
on: Switch on the compressor and
let it run for approximately 3
minutes to fill the sealant. The
inflation pressure of the tyre
after filling is unimportant.
11. Switch off the compressor.
12. Detach the hose from the seal
-
ant bottle connector and from the
tyre valve.
Return the Tyre Mobility Kit to its
storage location in the vehicle.
Carbon monoxide poisoning and suf
-
focation is possible if the engine is
left running in a poorly ventilated or
unventilated location (such as inside
a building).
Distributing the sealant
13. Immediately drive approxi
-
mately 7~10 km (4~6 miles or,
about 10 min) to evenly distribute
the sealant in the tyre.
Do not exceed a speed of 60 km/h
(35 mph). If possible, do not fall
below a speed of 20 km/h (12 mph).
whilst driving, if you experience any
unusual vibration, ride disturbance
or noise, reduce your speed and
drive with caution until you can
safely pull off of the side of the
road. Call for road side service or
towing.
To Next Page
Loading...
Need help?
General
