37
8
8
Maintenance Engine oil (Petrol)
Engine oil (Petrol)
Checking the engine oil level
Smartstream G1.0 T-GDi /Smart
-
stream G1.0 T-GDi 48V HEV
Smartstream G1.2
(Petrol engine) 1.4 MPI
1. Be sure the vehicle is on level
ground.
2. Start the engine and allow it to
reach normal operating tempera
-
ture.
3. Turn the engine off and wait for a
few minutes (about 10 minutes)
for the oil to return to the oil pan.
4. Pull the dipstick out, wipe it clean,
and re-insert it fully.
Radiator hose
Be very careful not to touch the
radiator hose when checking or
adding the engine oil as it may be
hot enough to burn you.
5. Pull the dipstick out again and
check the level. The level should
be between F (Full) and L (Low).
䳜 Do not overfill the engine oil. It
may damage the engine.
To Next Page
Loading...
Need help?
General
