OPERATION
WB140-2N, WB150-2N 2-49
When traveling up a hill or slope with an empty bucket, travel with the bucket directed in an upward position. When traveling
down a slope or hill with an empty bucket travel with the bucket facing downward. Never shift into neutral gear when on a
slope or hill.
If the machine should lose control or slide on the slope or hill, lower the bucket to the ground immediately to help stabilize the
machine.
TRAVELING OR WORKING IN SWAMPY OR WET AREAS
If you will be traveling or working in areas where the machine will be immersed in water, always check the depth of the water,
stability of the ground and current flow first.
It is advised to operate the machine in a water depth no deeper than 50 cm (20 in). A depth deeper than 50 cm (20 in) may
damage the machine.
After you have completed your work or travel through water or muddy areas always clean the machine and lubricate any com-
ponents that may have been immersed in the mud or water
To Next Page
Loading...
Need help?
General
