SAFETY
WB140-2N, WB150-2N 1-17
HIGH PRESSURE HOSES
Do not use bent, cut or cracked tubing or hoses which have been previ-
ously rejected because of leaks or other defects. Faulty hoses can burst
during operation causing injury or fire.
Repair or replace any loose or faulty fuel or hydraulic lines immedi-
ately. Do not operate the machine with damaged or leaking hoses or
lines.
Remember that working hydraulic systems are always under pressure. If
you have to add or drain hydraulic fluid, service or inspect the hydraulic
system, lower the equipment to the ground and release system pressure
and residual tank pressure before starting any work.
Leaks from pressurized hydraulic lines are extremely dangerous since
the spray from them can penetrate your skin and enter the bloodstream,
or the eyes.
Always wear thick gloves and protective goggles when working on the
hydraulic systems Use a sheet of cardboard or plywood to search for-
leaks.
If you are struck by a jet of hydraulic fluid under pressure, or if you are
injured even slightly, consult a doctor immediately for appropriate treat-
ment.
HIGH TEMPERATURES AREAS
When you stop the machine at the end of a job, remember the engine
coolant, oil, all engine parts, exhaust stack and the hydraulic system is
still hot and under pressure. If you attempt to drain engine coolant,
hydraulic fluid, or engine oil under these conditions, you expose your-
self to various dangers, including the risk of serious burns.
Carry out maintenance procedures described in this manual only when
the machine has had time to cool down.
ROTATING PARTS
Take particular care near rotating parts. Keep your body at a safedis-
tance.
If hands, clothing, or tools become entangled in the fan blades or fan
belt, severe injury may result. Keep well away from all rotating parts.
To Next Page
Loading...
Need help?
General
