CONTROLS 16
4.24Display mode SPEED/TR2 (trip master 2)
400324-01
– Press the button briefly and repeatedly until TR2 appears at the top right of the
display.
TR2 (trip master 2) runs constantly and counts up to 999.9.
The displayed value can be set manually with the button and the button . This is a
very practical function when riding using the road book.
Info
The TR2 value can also be corrected manually during the journey with the but-
ton and the button .
If 999.9 is exceeded, the value of TR2 is automatically reset to 0.0.
Press the button . Increases value of TR2.
Press the button . Reduces value of TR2.
Press the button
for 3 - 5 seconds.
Deletes value of TR2.
Press the button
briefly.
Next display mode
4.25Display mode SPEED/A1 (average speed 1)
400325-01
– Press the button briefly and repeatedly until A1 appears at the top right of the
display.
A1 (average speed 1) shows the average speed calculated on the basis of TR1 (trip mas-
ter 1) and S1 (stop watch 1).
The calculation of this value is activated by the first impulse of the wheel speed sensor
and ends 3 seconds after the last impulse.
Press the button . No function
Press the button . No function
Press the button
for 3 - 5 seconds.
The TR1, A1 and S1 displays are reset to 0.0.
Press the button
briefly.
Next display mode
4.26Display mode SPEED/A2 (average speed 2)
400326-01
– Press the button briefly and repeatedly until A2 appears at the top right of the
display.
A2 (average speed 2) shows the average speed on the basis of the current speed if the
stop watch S2 (stop watch 2) is running.
Info
The displayed value can differ from the actual average speed if S2 was not
timed after the ride.
Press the button . No function
Press the button . No function
Press the button
for 3 - 5 seconds.
–
Press the button
briefly.
Next display mode
To Next Page
Loading...
Need help?
General
