CLEANING, CARE 82
16.1Cleaning motorcycle
Note
Material damage Damage and destruction of components by high-pressure cleaning equipment.
– Never clean the vehicle with high-pressure cleaning equipment or a strong water-jet. The excessive pressure can penetrate electri-
cal components, socket connects, throttle cables, and bearings, etc., and can damage or destroy these parts.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
If you clean the motorcycle regularly, its value and appearance will be maintained over a long period.
Avoid direct sunshine on the motorcycle during cleaning.
– Seal the exhaust system to keep water out.
401061-01
– First remove coarse dirt particles with a gentle water spray.
– Spray very dirty areas with a normal motorcycle cleaner and then clean with a
paintbrush.
Motorcycle cleaner ( p. 116)
Info
Clean the vehicle with warm water containing normal motorcycle cleaner
and a soft sponge.
– After rinsing the motorcycle with a gentle spray of water, allow it to dry thoroughly.
–
Empty the carburetor float chamber. x ( p. 76)
Warning
Danger of accidents Reduced braking efficiency due to wet or dirty brakes.
– Clean or dry dirty or wet brakes by riding and braking gently.
– After cleaning, ride a short distance until the engine reaches operating tempera-
ture.
Info
The heat produced causes water at inaccessible locations in the engine and
the brakes to evaporate.
– Push back the protection covers of the handlebar grips to allow any water that has
penetrated to evaporate.
– After the motorcycle has cooled off, lubricate all moving parts and bearings.
– Clean the chain. ( p. 48)
– Treat bare metal parts (except for brake discs and exhaust system) with
anti-corrosion materials.
Cleaning and preserving materials for metal, rubber and plastic ( p. 116)
– Treat all plastic parts and powder-coated parts with a mild cleaning and care prod-
ucts.
Paint cleaner and polish for high-gloss and matte finishes, bare metal and plastic
surfaces ( p. 116)
To Next Page
Loading...
Need help?
General
