6-22 Maintenance
6.4.2.6 Setup at the first startup
(Make sure to perform the following procedure after updating the hard disk.)
(1) Turn on the power to the waveSurfer.
(2) Wait until the LeCroy's logo LeCroy fills the screen, then press [F4] until the
Phoenix will appear. (Hold it down for a while.)
(3) A message "Please Standby ..." will appear. Wait until the next screen appears.
(If this message does not appear, reboot Windows, then restart the waveSurfer
and perform Step (2) again. If the message does not appear even then, perform
the hard disk copying operation again.)
(4) If "End User License Agreement" appears on the screen, scroll down to the end
with the mouse and press the [Decline] button. (NEVER press the [Accept] button!
If you press the [Accept] button, you are forced to return to Section 4 to update the
hard disk again.)
(5) The screen is blackened for a while. Then the Windows startup screen appears.
(6) The following message appears informing you that the check of D drive now
starts. No operation is necessary. If there is no problem, the operation
automatically completes.
Checking file system on D:
(7) First [Welcome], then the [FBReseal] dialog box appears. If you are sure that the
dialog box contains the message "Machine Resealed! Click OK to reboot.", press
the [OK] button. Windows will automatically reboots itself.
To Next Page
Loading...
Need help?
General
