6-12 Maintenance
11. The Select Recover Type screen displays. Select recover option, as defined below:
[Recover Boot Partition] Recovers drive "C:" only. Drive “C:” is the drive that the
WaveSurfer application software is stored on. Drive "D:" is not recovered. (Drive
"D:" is the USERDATA area of the hard disk.)
[Recover Entire Drive] Select this button if you want to recover both the “C:” and
“D:” drives of the hard disk (Note: Any USERDATA will be erased if this option is
selected)
12. Read the license agreement and click [Accept] to proceed.
13. The following dialog box will be displayed. Click the [Yes] button.
z When you select [Recover Boot Partition], the dialog message is “This operation
will permanently overwrite the contents of your boot partition. Are you sure that
wish to continue?”
z When you select [Recover Entire Drive], the dialog message is “This operation will
permanently overwrite the contents of your entire drive. Are you sure that wish to
continue?”
14. The recovery starts, and the FirstWare Progress screen displays. No further selections
are required. The recovery takes about 10 minutes.
To Next Page
Loading...
Need help?
General
