Leica mojo3D, Vehicles and Implements 191
9.5 Exporting Vehicle or Implement Configurations
Exporting vehicle
or implement
configurations,
step-by-step
When you export vehicle configurations to a USB memory key, you will
overwrite any vehicle configurations that may already be on the USB
memory key.
Refer to "Appendix B Formatting USB Flash Drives" for important informa-
tion about using USB memory keys with the mojo3D products.
Do not turn off the mojo3D, or remove the USB memory key, while the data
export is under way.
To export vehicle or implement configurations, carry out the following steps:
1. The USB interface is on the lower left front of the
mojo3D display. Lift the rubber cover and insert a
compatible USB memory key into the USB slot.
To Next Page
Loading...
Need help?
General
