238
Leica mojo3D, Virtual Wrench™ Remote Service
12.4 Upgrading Software via USB Flash Drive
General informa-
tion
A new version of software may be installed from a USB Flash Drive.
Refer to "Appendix B Formatting USB Flash Drives" for important informa-
tion about using USB drives with the mojo3D products.
Caution Do not turn off the mojo3D, or remove the USB Flash Drive, while the software
upgrade is under way.
Upgrading soft-
ware with a USB
Flash Drive, step-
by-step
To upgrade the mojo3D software via USB Flash Drive, carry out the following steps:
1. The USB interface is on the lower left front of the
mojo3D display. Lift the rubber cover and insert a
compatible USB Flash Drive into the USB slot.
To Next Page
Loading...
Need help?
General
