242
Leica mojo3D, Virtual Wrench™ Remote Service
12.6 Backing Up Current Software
General informa-
tion
Once you have installed new software by downloading from Virtual Wrench™, you
can backup the new software onto a USB Flash Drive. This is useful in speeding up
the process when upgrading other mojo3D units.
Refer to "Appendix B Formatting USB Flash Drives" for important informa-
tion about using USB drives with the mojo3D products.
Caution Do not turn off the mojo3D, or remove the USB Flash Drive, while the software back
up is under way.
Backing up current
software, step-by-
step
To back up the current software onto a USB Flash Drive, carry out the following steps:
1. The USB interface is on the lower left front of the
mojo3D display. Lift the rubber cover and insert a
compatible USB Flash Drive into the USB slot.
To Next Page
Loading...
Need help?
General
