Lenze C520 User Manual

5.12.2 Saving the parameter sengs
Use the "Save user data" device command to save the parameter sengs of the controller
locally on the SD card of the device.
The parameters are part of the boot applicaon. When creang the boot applicaon, the
parameter sengs are saved automacally on the SD card of the device.
Parameter
Address Name / seng range / [default seng] Informaon
0x2022:003 Device commands: Save user data
•
When the device command has been executed successfully, the value
0 is shown.
•
Do not switch o the supply voltage or remove the SD card from the
controller during the storage process!
•
When the controller is switched on, all parameter sengs are
automacally loaded from the SD card into the RAM memory of the
controller.
0 O / ready Only status feedback
1 On / start The parameter sengs are saved on the SD card.
2 In progress Only status feedback
3 Acon cancelled
4 No access
5 No access (Device disabled)
101 No SD card connected
102 SD card is write protected
103 SD card is full
5.12.3 Reset parameters to default
Use the "Load default sengs" device command to reset the parameters to the default
seng.
By execung this device command, all parameter sengs made by the user are
temporarily lost!
If the changes are not saved, the parameters stored on the SD card will not be changed.
Parameter
Address Name / seng range / [default seng] Informaon
0x2022:001 Device commands: Load default sengs
•
All parameter changes made by the user are lost during this process!
•
When the device command has been executed successfully, the value
0 is shown.
•
Loading parameters has a direct eect on cyclic communicaon: The
data exchange for control is interrupted and a communicaon error is
generated.
0 O / ready Only status feedback
1 On / start All parameters in the RAM memory of the controller are reset to the
default seng that is stored in the controller rmware as default seng.
2 In progress Only status feedback
3 Acon cancelled
4 No access
5 No access (Device disabled)
Commissioning
Parameterize controller
Saving the parameter sengs
23

Lenze C520 Specifications

General

Brand	Lenze
Model	C520
Category	Controller
Language	English