To Next Page

To Previous Page

9.2 Opcal device idencaon

For applicaons including several controllers it may be dicult to locate a device that has

been connected online. The "Opcal device idencaon" funcon serves to locate the

controllerby means of blinking LEDs.

Details

In order to start the visual tracking, set 0x2021:001 = "Start [1]".

Aer the start, both LEDs "RDY" and "ERR" on the front of the controller synchronously blink

very fast.

"RDY" LED (blue) "ERR" LED (red) Status/meaning

Both LEDs are blinking in a very rapidly

synchronous mode

"Visual tracking" funcon is acve.

The blinking rate can be set in 0x2021:002.

Parameter

Address Name / seng range / [default seng] Informaon

0x2021:001 Opcal tracking: Start detecon 1 = start opcal device idencaon.

•

Aer the start, the two LEDs "RDY" and "ERR" on the front of the

controller are blinking with a blinking frequency of 20 Hz for the

blinking duraon set in 0x2021:002. The seng is then automacally

reset to "0" again.

•

If the funcon is reacvated within the blinking me set, the me is

extended correspondingly.

•

A manual reset to "0" makes it possible to stop the funcon

prematurely.

0 Stop

1 Start

0x2021:002 Opcal tracking: Blinking duraon

0 ... [5] ... 6000 s

Seng of the blinking duraon for the visual tracking.

Device funcons

Opcal device idencaon

Lenze C520 User Manual

Other manuals for Lenze C520