Lenze C520 User Manual

Error message Error type Descripon
MMC - slave ... ident failed - CoE ...
(error ...)
ERROR An error occurred in the specied slave while the EtherCAT bus booted and the
addional idencaon parameters from the "mmc-0-ident.csv" conguraon le
were checked. For further informaon see general error codes
(L_ETC_ERRORCODE).
Modular machine conguraon: Only
one instance of L_ETC_MMCController
allowed!
ERROR This message is transmied when the EtherCAT master conguraon is generated if
more than one instance of the L_ETC_MMCController funcon block is used in the
applicaon. Please note: An instance might also have been created in a library!
Conguring the network
EtherCAT
Modular machine conguraon
69

Lenze C520 Specifications

General

Brand	Lenze
Model	C520
Category	Controller
Language	English