Safety instructions
General safety and application notes for Lenze controllers
2
2.1
2.1-3
EDSVF9333V EN 3.0-06/2005
Special controller variants support safety functions (e.g. ”safe torque off”,
formerly ”safe standstill”) according to the requirements ofAnnex I No. 1.2.7
of the EC Directive ”Machinery” 98/37/EC, EN 954-1 Category 3 and
EN 1037. Strictly observe the notes on the safety functions given in the
documentation on the respective variants.
The controllers do not require any maintenance if the prescribed conditions
of operation are observed.
If the ambient air is polluted, the cooling surfaces of the controller may
become dirty or the air vents of the controller may be obstructed. Therefore,
clean the cooling surfaces and air vents periodically under these operating
conditions. Do not use sharp or pointed tools for this purpose!
Recycle metal and plastic materials. Ensure professional disposal of
assembled PCBs.
The product-specific safety and application notes given in these Operating
Instructions must be observed!
Safety functions
Maintenance and servicing
Disposal
To Next Page
Loading...
Need help?
General
