Preface and general information
How to use this System Manual
Information provided by the System Manual
1
1.1
1.1.1
1.1-1
EDSVF9333V EN 3.0-06/2005
1.1 How to use this System Manual
1.1.1 Information provided by the System Manual
This System Manual is intended for all persons who design, install,
commission, and adjust the 9300 vector frequency inverter.
Together with the System Manual (extension), document number
EDSV9383V-EXT and the catalogue it forms the basis for project planning for
the manufacturer of plants and machinery.
The System Manual is the basis for the description of the 9300 vector
frequency inverter. Together with the System Manual (extension),
document number EDSVF9383V-EXT, a complete System Manual is
available:
ƒ The features and functions are described in detail.
ƒ Examples describe how to set the parameters for typical applications.
ƒ In case of doubt, the Operating Instructions delivered together with the
9300 vector frequency inverter always apply.
Contents of the System Manual Contents of the System Manual (extension)
1 Preface 1 Preface
2
Safety –
3 Technical data –
4 Installing the basic device –
5 Wiring the basic device –
6 Commissioning –
7 Parameter setting –
8
Configuration
2
Configuration
8.1 Description of function blocks
Diameter calculator (DCALC)
Master frequency input (DFIN)
Master frequency output (DFOUT)
Master frequency ramp function
generator (DFRFG)
Master frequency processing
(DFSET)
Internal motor control with V/f
characteristic control (MCTRL1)
Internal motor control with vector
control
MCTRL2
2.1 Configuring with Global Drive
Control
2.2
Basic configurations
2.3 How to use function blocks
2.4 Function blocks
(Description of the other function
blocks)
2.5 Monitoring
8.2 Code table
8.3 Selection lists
8.4 Table of attributes
9 Troubleshooting and fault elimination –
10 DC-bus operation –
11 Safe standstill –
– 3 Application examples
– 4 Signal flow diagrams
12 Accessories –
13 Appendix 5 Appendix
Target group
Contents
To Next Page
Loading...
Need help?
General
