HDMI-TPS-RX110AY – User's Manual 28
Ports
User can set the name and command injection port to each sources and destinations as well as command
the IR Interface section.
Infra tab - Ports window
Clear all IR codes
Event Manager
The feature means that the device can sense changes on its ports and able to react
is based on users’ feedbacks. In many cases internal events (such as signal present
or HDCP active) are necessary to display but it is not easy when the device is hard
to access (e.g. built under the desk).
setup is that after a certain type of signal has been detected on I1 port, the port has to be switched to O1.
events number depends on the device what you are using actually.
Numerous new ideas and requests have been received in connection with the features and settings of the
functions implemented. The Event editor can be opened by pressing the Edit button at each Event.
There is a gray bar on the left of the Event panel in each line. If a condition and an action are set and the Event
is enabled, the bar is displayed in green.
Control menu, Event Manager tab
To Next Page
Loading...
Need help?
General
