General System Overview Product Description
1 - 8 046-004667-00 A7™ Operating Instructions
If the battery capacity is too low, power supply failure will result. A high-level alarm will be triggered
and the message Low Battery Voltage! will be displayed in the technical alarm area. In this case,
apply AC power to the A7 Anesthesia System to resume operation and charge the battery supply.
1.1.12 Workplace Ergonomics
The A7 is a full-featured anesthesia delivery work station. The raised perimeter of its stainless steel
work surface retains items that might otherwise roll or slide off its edge. The work surface light has
high and low brightness settings. The wrap-around handle enables fine positioning of the machine.
Three (3) large drawers are available for storage. All drawers can be locked with a key. Rail mounts on
both sides of the machine enable mounting of patient monitors and most standard attachment arms
for other devices. Non-slip footrest and central brake are provided. The top shelf can be used to
mount additional equipment. An auxiliary work surface can be pulled out by depressing it inward
when the drawer is closed.
The operator of the A7 should be positioned in front of the monitor at a comfortable distance to view
all displayed waveforms, text, and controls.
1.1.13 Hook
There is a hook located on the front of the breathing system that can be used to hang the tubes of
the breathing circuit.
Battery supply is not installed.
FIGURE 1-1 Battery Status
PART(S) DESCRIPTION
To Next Page
Loading...
Need help?
General
