the images. Gray rank of low level is not obviously lean to red or green, and
then the test is passed.
Images of different color rank levels can be distinguished easily with a
smooth transition, and the brightness transition can also be obtained from
the images.
If different kinds of color graphics appear on the screen where the color and
the word of each graphics are consistent, test is passed.
Press [Set] to switch among the 3 interfaces, if the images are clear with
letters and characters easy to be recognized and there is no ambiguous
display or variance among them, the test is passed;
Press [Set] to enter pure color interfaces of green, blue, red, black and white.
Observe the LCD screen. Check bright point and dark point in the black and
white interfaces. Criterion for pass: bright point number is 0; number of
continuous dark point pair is ≤3, and no continuous dark point appears in the
image area; there are no three or more than three continuous dark point;
dark point defects number is ≤7, and number of dark points in the image area
is ≤2; point flash defects is 0; space between fail points is ≥5mm.
4. Click [OK] on the touch screen or press [ESC] on the keyboard to return to the main screen
interface.
7.1.4 Touch Screen Test
1. Log on as the "Service"; refer to chapter 6.1 for details.
2. Press the [F10] key on the keyboard to enter setup menu, and click [Maintenance] to enter the
screen.
3. Click [Setup] and select [Test Touch Screen] to enter the screen, test methods are the same as
in main screen test.
To Next Page
Loading...
Need help?
General
