11-4 DICOM
the AE Title of the accepted SCU is preset as MMM, then in the figure above, the AE
Title of Local should be MMM, and the AE Title of print server should be AAA.
DICOM Server Setting
Name of the device supporting DICOM services.
IP Address IP address of the server.
Ping
You can ping other machines to verify connection after entering the
correct IP address. Also you can check the connection of the
already added server in the list.
Click to add servers to the device list.
[Set DICOM Service] Click to enter DICOM service preset, see “11.1.3 DICOM Service”.
Click to delete the selected server (s) in the device list.
Note:
If the currently entered name has already existed, the system will pop up: “The server
name exists!” Click [OK] to enter another name.
11.1.3 DICOM Service
When the system is configured with DICOM basic function module, and installed DICOM
Worklist and Storage Commitment, the corresponding preset settings can be found in DICOM
Service screen.
Enter [Setup]-> [DICOM Preset], Click [Set DICOM Service], you can add, delete and set the
property of the service on DICOM server.
11.1.3.1 Storage
1. Enter [Setup]-> [DICOM Preset]-> [Set DICOM Service]-> [Storage].
2. Select device, enter the information. For device setting, please refer to “11.1.2 DICOM
Preset.”
Click [Add] to add the service to the Service list;
Select an item in the service list, change the parameters in the above area, and click
[Update] to update the item in the service list; click [Cancel] to cancel changing.
Select an item in the service list, and click [Delete] to delete the service.
Select an item in the service list, and click [Default] to set the server to be the default
service.
3. Select an item in the service list, and click [Verify] to verify the connection.
4. Click [Exit] to save and exit the preset.
To Next Page
Loading...
Need help?
General
