NAiS FP Series User Manual

FPΣ 7.4 Wiring of Communication Cassette
7-11
7.4 Wiring of Communication Cassette
This section explains about the wiring of optional communication cassette.
7.4.1 Wiring the Connector with the Communication Cassette
The communication connector (provided with the communication cassette) has a
screw-type terminal block. Use the following for wiring.
Figure 136: FPΣ Communication connector
Accessory communication connector
The communication connector made by Phoenix Contact Co. should be used.
Number
of
pin
Model No. of Phoenix Contact Co.
N
um
b
er o
f
p
i
n
Model No. Product No.
5 pins MC1,5/5-ST-3,5 1840396
Suitable wire (Twisted wire)
Size Cross-sectional area
AWG#28 to 16 0.08 mm
2
to 1.25 mm
2
Pole terminal with a compatible insulation sleeve
If a pole terminal is being used, the following models are marketed by Phoenix Contact
Co.
Manufacturer
Cross-sectional
area
Size Product number
0.25 mm
2
AWG#24 AI 0,25-6 YE
Phoenix
0.50 mm
2
AWG#20 AI 0,50-6 WH
Phoenix
Contact Co.
0.75 mm
2
AWG#18 AI 0,75-6 GY
1.00 mm
2
AWG#18 AI 1-6 RD
Pressure welding tool for pole terminals
Manufacturer
Model No. of Phoenix Contact Co.
M
anu
f
ac
t
urer
Model No. Product No.
Phoenix Contact Co. CRIMPFOX UD6 12 04 43 6

NAiS FP Series Specifications

General

Brand	NAiS
Model	FP Series
Category	Controller
Language	English