27
Microscopy
2
Warning
• Before using the product, thoroughly read the “Safety Precautions” at the beginning of this
manual, and heed all warnings and cautions written therein.
• To use other equipment such as epi-fl attachment or differential interference contrast
attachment, refer to the respective manuals and heed all warnings and cautions written
therein.
Caution
When using the PFS Motorized Nosepiece, use the “Ti Control” setup software for Ti series to
register the objective information from a PC. PFS Motorized Nosepiece will not function
properly unless the objective information has been registered correctly. For details on using
“Ti Control”, refer to the “Ti Control” instruction manual.
When using Ti-E or Ti-E/B with
TI-HUBC/A Hub Controller A attached on the back
Refer to the instruction manual provided with TI-HUBA/B Hub Controller A
The TI-HUBC/A Hub Controller A is used to control the motorized components.
When the TI-HUBC/A Hub Controller A is attached to the back of the microscope, operation
procedures for the motorized devices will change. Refer to the instruction manual for the TI-HUBC/A
Hub Controller A, and prepare and observe accordingly.
Note that the following two operations cannot be performed electrically even if the TI-HUBC/A Hub
Controller A is attached:
• 6V 30W lamp operation: Use the dia illumination lamp ON/OFF switch.
• 6V 30W lamp voltage adjustment: Use the brightness control knob on the microscope body or
on the power supply device.
To Next Page
Loading...
Need help?
General
