89
Assembly
4
Warning
• Before assembling or connecting devices, thoroughly read the “Safety Precautions” at the
beginning of this manual, and heed all warnings and cautions written therein.
• To prevent electric shock, fire, and product damage, turn off the power switch on all
devices, and unplug the power cords.
Caution
• Take care to avoid pinching your fingers and hands.
• Scratches and dirt on optical components (i.e. lenses and filters) will degrade the
microscope image. Keep them free of scratches, dust, fingerprints, and other dirt.
• The product is a precision optical instrument. Handle the product with care, and avoid
subjecting it to strong physical shocks. In particular, the accuracy of objectives may be lost
by even weak physical shocks.
Caution
Notes on setup
• To use the PFS Motorized Nosepiece, you will need to register the objective information on
the microscope. After assembling the product, connect a PC and set up the microscope
before use.
• For setup, use the “Ti Control” setup software for Ti series. For details on using the
software and setting up the microscope, refer to the “Ti Control” instruction manual.
This chapter describes the installation, assembly, and setup of the product in the actual sequence.
Assemble the product as described in this chapter.
When using Ti-E or Ti-E/B with TI-HUBC/A Hub Controller A
Refer to the instruction manual provided with TI-HUBC/A Hub Controller A
To Next Page
Loading...
Need help?
General
