118Service Manual – SC6000 38 - Squeegee System
Squeegee
The squeegee has a front and rear squeegee blade, creating
a vacuum area in between where water can be drawn up
from the fast moving airow. The front squeegee blade is
intended to permit wastewater to enter the middle of the
squeegee’s vacuum area, yet still maintain enough of a seal
to not completely lose vacuum. The rear squeegee blade is
intended to create a tighter seal to the oor, and also act as
a wiper to prevent wastewater from being left behind the
machine.
Maintenance and Adjustment
Squeegee Blade Cleaning and Inspection
Periodically clean and inspect the squeegee
assembly and blades (D).
1. Remove the squeegee hose (A) and move it
off to the side.
2. Loosen the two thumb nuts (B).
3. Using the two carrying handles (C), slide the
squeegee assembly off the lift mechanism.
4. Clean the squeegee blades (D) and suction
area between the blades with soap and
water.
5. Inspect the squeegee blades for nicks, tears,
and worn leading edges. If a squeegee blade
is worn or damaged, it may be turned around with a fresh edge facing down/forward up to four times
before complete blade replacement is required.
A
A
B
C
D
To Next Page
Loading...
Need help?
General
