Notifier AFP-400 Installation Manual

Using the CRT-2 for Alter Status $SSHQGL[ ( 7HUPLQDO ,QWHUIDFH 3URWRFRO
AFP-300/AFP-400 Installation PN 50253:C1 05/22/97 E-7
8VLQJWKH&57IRU$OWHU6WDWXV
2YHUYLHZ
This section shows how to do Alter Status functions, Table E-5, from a CRT-2.
7DEOH ( $OWHU 6WDWXV )XQFWLRQV
$FFHVVLQ
J
$OWHU6WDWXV2
S
WLRQV
Access the Alter Status function from the CRT-2 by following these steps.
1. Turn on the CRT-2 connected to the control panel.
2. Press the Alter Status function key. The control panel displays the Alter Status
menu options:
3. Enter the Status Change Password. The factory default Status Change Password is
11111. The password does not display on the CRT-2. Five asterisks will appear in
place of the password:
The Alter Status Options menu appears:
From the Alter Status Options menu, you can select options 1-5.
Function Lets you...
Disable Enable or disable detectors, modules, or panel circuits.
Alarm/Pre-alarm Change the Alarm and pre-Alarm levels of any addressable detector in the
system.
Clear Verification Clear the verification counter for all the addressable detectors in the system.
Clear History Clear the contents of the history buffer.
Set Action/Alert Set the pre-Alarm for the Alert or Action.
(QWHU 6WDWXV &KDQJH 3DVVZRUG RU (VFDSH WR $ERUW
C
Press

11111
Press
 'LVDEOH  $ODUP3UH DOD UP  &OHDU 9HULILFD WLR Q  &OHDU +LVWRU\  $OHUW$FW LRQ
www.PDF-Zoo.com

Notifier AFP-400 Specifications

General

Brand	Notifier
Model	AFP-400
Category	Control Panel
Language	English