3-1
Operation of Operator
The Operator is a display operation panel for the 3G3M1 Series Inverter.
3-1-1
Part Names and Descriptions
The table below shows the name and function of each part of the Operator.
USB connector
LED
PRG/RESET key
Enter key
Data display
RUN key
STOP key
Decrement key
Increment key
Display Name Description
Error LED Lights (red) when the inverter trips.
For how to reset a trip error state, refer to How to Reset a Trip
State on page 9-
2.
Program LED Lights (green) when editable data (set value) is displayed on
the data display.
RUN LED Lights (green) when the inverter is running (during output to
the motor). Lights during deceleration after RUN command
OFF. Goes out while the RUN command is ON at Frequency
Reference 0 Hz as there is no output (excluding Zero Speed
Control).
Monitor LED (Hz) Lights (green) when a frequency value is displayed on the da-
ta display.
Monitor LED (A) Lights (green) when a current value is displayed on the data
display.
x10 LED This x10 LED lights (green) when the displayed data exceeds
9999. “Currently displayed data x 10” is the actual data.
Data display Displays (in red) various data such as a parameter value, fre-
quency value, or set value.
RUN command LED
indicator
LED (top right)
Lights (green) when the Run command is set to Digital Oper-
ator, and flashes (green) when the key is enabled by the
forced operator function.
(This indicates that the
key is enabled on the Digital Op-
erator.)
RUN key Starts inverter operation. Note that this key is enabled when
the RUN command is set to Digital Operator
.
STOP key Stops the inverter (deceleration stop).
3 Operation and Test Run
3-2
M1 Series Standard Type User's Manual (I669)
To Next Page
Loading...
Need help?
General
