6-9SectionSystem Settings
136
• Comm. Auto-return page 141
• Time-out Interval page 142
• Retry Counts page 142
• Comm. A Method page 125
(For the bar code reader, refer to page 144.)
• Comm. B Method page 125
For details on each setting, refer to the pages indicated.
6-9-2 Setting the Start-up Wait Time
The Start-up Wait Time is the time lapse until the NT21 switches to the RUN
mode
after it has been turned ON. Set this item if it takes some time for
the host to
start operation. Nothing is displayed during the Start-up Wait Time.
The setting range is 0 to 10 seconds. The default (factory) setting is 00sec.
Set the system start-up wait time with the first Memory Switch Setting Screen
(1/4)
as
shown below
. (Refer to
6-9-1 Memory Switch Setting Screens
for details
on displaying the Screen.)
Press Start-up Wait Time to display the re-
quired time lapse.
The setting option changes each time the
touch
switch is pressed, according to the fol
-
lowing sequence.
01 02 03 .... 09 10 00 01 ....
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [
] (previous screen) touch switch, then make the setting.
• To confirm
the settings and quit the memory switch setting screen, press the
Quit
touch switch. The settings made last will be set and the NT21
will return to
the MAINTENANCE MODE MENU screen.
• To
quit the memory switch setting screen
without confirming the settings, press
the Abort touch switch. The NT21 will return to the MAINTENANCE MODE
MENU screen with the previous settings still in effect.
6-9-3 Setting the Key Press Sound
It
is possible to set whether or not the key sound is sounded when a touch switch
on the NT21 screen is pressed.
• ON: When
a touch switch is pressed, the key sound sounds for 0.2 seconds.
• OFF: The key sound does not sound when touch switches are pressed.
The default (factory) setting is ON.
Turn the key-press sound ON and OFF with the first Memory Switch Setting
Screen
(1/4) as
shown below
. (Refer to
6-9-1 Memory Switch Setting Screens
for details on displaying the Screen.)
Press Key Press Sound to display ON or
OFF.
The setting option changes each time the
touch switch is pressed.
To Next Page
Loading...
Need help?
General
