Installation and commissioning
8 - 5
Value for Bed plate
parameter "204" cut-out size Seam pattern size
1 7 mm x 7 mm 5 mm x 5 mm
2 8 mm x 8 mm 6 mm x 6 mm
3 9 mm x 9 mm 7 mm x 7 mm
4 10 mm x 10 mm 8 mm x 8 mm
5 11 mm x 11 mm 8 mm x 9 mm
6 10 mm x 14 mm 8 mm x 12 mm
8.04 Setting the seam pattern size
After the machine has been switched on for the first time, first of all the seam
pattern sizes set in the machine control unit must be checked and corrected if
necessary. The seam pattern size depends on the cut-out size of the bed plate
and is set with parameter "204". If these instructions are not observed there is a
risk of severe damage to the machine!
8.04.01 Establishing the value for parameter "204"
● Measure the size of the cut-out in bed
plate 1.
● With the use of the table below
determine the value for parameter "204".
● Set „parameter "204", which is the seam
pattern size, in accordance with Chapter
8.04.02 Changing parameter "204".
1
0
4
-0
0
6
Fig. 8 - 05
1
To Next Page
Loading...
Need help?
General
