11 - 4
Input
● Start the second needle entry position (P02) with the corresponding plus/minus keys.
● Confirm input with Enter.
Machine moves automatically to input of the next parameter.
● Start the third needle entry position (P03) with the corresponding plus/minus keys.
● Confirm input with Enter.
Machine moves automatically to input of the next parameter.
● Select the total number of stitches "P05" with the corresponding plus/minus key.
● Confirm input with Enter.
Machine moves automatically to input of the next parameter.
● Select the seam pattern „PO7“ with the corresponding plus/minus key
● Confirm the input with the Enter key.
The program moves automatically to the input of the next parameter.
● Switch the end knotting function „P08“ on/off with the corresponding plus/minus key.
● By pressing the seam pattern input key the values entered are stored and the machine
is in the basic position of the sewing mode.
By pressing the sewing mode/parameter input key the values are also stored,
and the machine is then in the parameter input mode.
By pressing the basic position key the seam pattern input is interrupted, the
old values are kept and the machine changes to the sewing mode.
To achieve the best results, cutting should take place at the left needle entry
position. This is achieved through the number of stitches and the location of the
needle entry positions.
To Next Page
Loading...
Need help?
General
