Using the touch panel keys
13
4
5
6
2
1 Recalls equalizer curves
= For details, refer to Using the equalizer
on page 175.
2 Sends a band command
Touch to send a band command to the exter-
nal unit.
p Operation varies depending on the ex-
ternal unit connected. (In some cases,
the external unit may not respond.)
3 Uses [F1] through [F4] to operate the ex-
ternal unit
The external unit can be operated by transmit-
ting the operating commands set to “F1”
through “F4”.
p The operating commands set to “F1”
through “F4” vary depending on the ex-
ternal unit.
p Some functions may not be used until
you touch and hold the key.
4 Switches between automatic and manual
function
You can turn automatic and manual function
on or off.
You can switch between “Auto” and
“Manual” functions of the external unit con-
nected.
Initially, this function is set to “Auto”.
p Operating commands set for “Auto”
and “Manual” operations vary depend-
ing on the external unit connected.
5 Sends a command [a], [b], [c], or [d]
Touch to operate the external unit.
p Operation varies depending on the ex-
ternal unit connected. (In some cases,
some functions may not be used until
you touch and hold the key.)
6 Sends a [1] key to [6] key command
The external unit can be operated by transmit-
ting the operating commands set to “1” key
through “6” key.
p Operation varies depending on the ex-
ternal unit connected. (In some cases,
some functions may not be used until
you touch and hold the key.)
En
149
Chapter
31
Using the external unit (EXT1, EXT2)
Using the external unit (EXT1, EXT2)
To Next Page
Loading...
Need help?
General
