p The location is also stored when you touch
[Scroll] in the location confirmation screen.
p If no location is stored in Destination His-
tory, you cannot select [History]. (If you
perform a route calculation, you can select
[History].)
p “History” can store up to 100 locations. If
the entries reach the maximum, the new
entry overwrites the oldest one.
1 Touch [Home] on the map screen and
then touch [Navigation].
= For details of the operations, refer to Screen
switching overview on page 28.
2 Touch [History].
The “Destination History” screen appears.
3 Touch the entry you want.
The searched location appears on the map
screen.
= For the subsequent operations, refer to Set-
ting a route to your destination on page
48.
Searching for a locat ion by
coordinates
Entering a latitude and longitude pinpoints
the location.
1 Touch [Home] on the map screen and
then touch [Navigation].
= For details of the operations, refer to Screen
switching overview on page 28.
2 Touch [Coordinate].
The “Coordinate Input Menu” screen ap-
pears.
3 Touch [Longitude].
The “Enter Longitude” screen appears.
4 Enter the longitude, and then touch
[OK].
The screen returns to the previous screen.
p To enter W 50°1’2.5” for example, touch [W],
[0], [5], [0], [0], [1], [0], [2], and [5].
5 Touch [Latitude].
The “Enter Latitude” screen appears.
6 Enter the latitude, and then touch [OK].
The screen returns to the previous screen.
p To enter N 5°1’2.5” for example, touch [N],
[0], [5], [0], [1], [0], [2], and [5].
7 Touch [OK].
The searched location appears on the map
screen.
= For details, refer to Setting a route to your
destination on page 48.
En
46
Chapter
08
Searching for and selecting a location
To Next Page
Loading...
Need help?
General
