Pioneer SC-LX904 User Manual

161
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Double Bass Off This can be selected only when "Conguration" -
"Subwoofer" is set to "1ch" or “2ch” and "Front" is
set to "Large".
Boost bass output by feeding bass sounds from the front
left and right, and center speakers to the subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
• The setting will not automatically be congured
even if you performed Full Auto MCACC.
• This setting is disabled when the IMAX sound mode has been applied. However, when
the "IMAX User Setting" (
p164) is "Manual" (default value is Auto), it is enabled.
 Distance
Set the distance from each speaker to the listening position. If multiple settings
are saved in the MCACC Memory, press on the remote controller, and select
the MCACC Memory rst in "AV Adjust" - "MCACC" - "MCACC Memory".
Setting Item Default Value Setting Details
Front Left 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Center 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Front Right 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Height 1 Left 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Height 1 Right 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Height 2 Left 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Height 2 Right 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Surround Right 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Surr Back Right 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Surr Back Left 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Surround Left 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Subwoofer 1 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
Subwoofer 2 10' 0"/3.00 m Specify the distance between each speaker and
the listening position.
• Default values vary depending on the regions.
•
Distance units can be switched by pressing MODE on the remote controller. When the unit
is set as feet, you can set between 0' 0" 1/2 and 30' 0" in increments of 1/2. When the unit
is set as meters, you can set between 0.01 m and 9.00 m in increments of 0.01 m.

Pioneer SC-LX904 Specifications

General

Brand	Pioneer
Model	SC-LX904
Category	Receiver
Language	English