184
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Subwoofer 0.0dB Control the effect of standing waves for the
subwoofer.
1. After selecting "Filter" with
/ , select the lter
to be adjusted from "1" to "3" with / and
press ENTER.
2. After selecting the central frequency with / ,
adjust the bandwidth with / , then adjust
the attenuation with / . The central frequency
can be selected between "63Hz" and "250Hz".
The bandwidth can be selected between "2.0"
and "9.8" (0.2 intervals). Attenuation can be
selected between "0.0dB" and "12.0dB" (0.5dB
intervals).
EQ Adjust
If you perform Full Auto MCACC then settings are automatic, but you can also
adjust the output volume of the range of each connected speaker to suit your own
preferences. You can adjust the volume of the different sound ranges for each of
the speakers. You can select up to 4 bands for the Subwoofer and 9 bands for all
other speakers. If the overall volume balance changes by adjusting the volume of
each frequency, you can readjust the balance in "Trim".
Setting Item Default Value Setting Details
Front Left 0.0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
/ , adjust
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with / . To
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
Setting Item Default Value Setting Details
Center 0.0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
/ , adjust
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with / . To
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Conguration"
- "Speaker Channels" matches the number of
connected channels.
Front Right 0.0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
/ , adjust
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with / . To
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
To Next Page
Loading...
Need help?
General
