163
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and Off.
Setting Item Default Value Setting Details
Speaker
Virtualizer
On "On": The listening mode with virtual speaker effect
such as F.S.Surround can be selected.
"Off": The listening mode with virtual speaker effect
such as F.S.Surround cannot be selected.
Audio Adjust
Dual Mono/Mono
Change the settings of multiplex audio playback.
Setting Item Default Value Setting Details
Dual Mono Main Set the audio channel or language to be output
when playing multiplex audio or multilingual
broadcasts, etc.
"Main": Main channel only
"Sub": Sub channel only
"Main/Sub": Main and sub channels are output at
the same time.
• For multiplex audio broadcasts, pressing the
button on the remote controller will display "1+1"
on the main unit’s display.
Mono Input
Channel
Left + Right Set the input channel to play 2-ch digital sources
such as Dolby Digital, or 2-ch analog/PCM sources
in the Mono listening mode.
"Left": Left channel only
"Right": Right channel only
"Left + Right": Left and right channels
Dolby
Change the setting of when Dolby signals are input.
Setting Item Default Value Setting Details
Loudness
Management
On When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the Midnight function that allows you to enjoy
surround at low volumes is xed to off when playing
Dolby Digital Plus/Dolby TrueHD.
"On": When this function is used
"Off": When this function is not used
To Next Page
Loading...
Need help?
General
