183
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Surround Left 10' 0" / 3.00 m The test pulse is output from this speaker and
the benchmark Front Left speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
Surround Right 10' 0" / 3.00 m The test pulse is output from this speaker and
the benchmark Front Right speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
Surr Back Left 10' 0" / 3.00 m The test pulse is output from this speaker and the
benchmark Surround Left speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
Surr Back Right 10' 0" / 3.00 m The test pulse is output from this speaker and the
benchmark Surround Right speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
Subwoofer 1 10' 0" / 3.00 m The test pulse is output from this subwoofer and
the benchmark Front Left speaker, so adjust the
distance so the point where the test pulse is heard
is in the middle of the two speakers.
Subwoofer 2 10' 0" / 3.00 m The test pulse is output from this subwoofer and
the benchmark Subwoofer 1, so adjust the distance
so the point where the test pulse is heard is in the
middle of the two speakers.
• Default values vary depending on the regions.
•
Distance units can be switched by pressing MODE on the remote controller. When the unit
is set as feet, you can set between 0' 0" 1/2 and 30' 0" in increments of 1/2. When the unit
is set as meters, you can set between 0.01 m and 9.00 m in increments of 0.01 m.
Standing Wave
This controls the affect of the standing waves that occur when sound waves
reverberating off obstacles such as walls interfere with the original sound waves.
Setting Item Default Value Setting Details
Main 0.0dB Control the effect of standing waves for speakers
other than the center speaker and the subwoofer.
1. After selecting "Filter" with
/ , select the lter
to be adjusted from "1" to "3" with
/ and
press ENTER.
2. After selecting the central frequency with
/ ,
adjust the bandwidth with / , then adjust
the attenuation with / . The central frequency
can be selected between "63Hz" and "250Hz".
The bandwidth can be selected between "2.0"
and "9.8" (0.2 intervals). Attenuation can be
selected between "0.0dB" and "12.0dB" (0.5dB
intervals).
Center 0.0dB Control the effect of speaker standing waves for the
center speaker.
1. After selecting "Filter" with
/ , select the lter
to be adjusted from "1" to "3" with / and
press ENTER.
2. After selecting the central frequency with / ,
adjust the bandwidth with / , then adjust
the attenuation with / . The central frequency
can be selected between "63Hz" and "250Hz".
The bandwidth can be selected between "2.0"
and "9.8" (0.2 intervals). Attenuation can be
selected between "0.0dB" and "12.0dB" (0.5dB
intervals).
To Next Page
Loading...
Need help?
General
