7.53
FINAL DRIVE
7
9. If the solenoid was removed for servicing, inspect the tip
of the solenoid for wear. If the tip of the solenoid is
flattened the solenoid must be replaced.
10. Remove the clutch gear from the gearcase cover.
11. Inspect the shift lever (A), shift lever spring (B), shift return
springs (C), and shift yoke (D) for excessive wear or
damage. If disassembly is required proceed to the next step.
If no disassembly is required proceed to “Rear Gearcase
Assembly.”
12. Loosen the lock assembly pin.
13. Remove the pin from the gearcase cover.
14. Carefully remove the shift yoke assembly from the
gearcase cover.
A
B
C
D
To Next Page
Loading...
Need help?
General
