10.12
9850043 R01 - 2017-2021 RANGER 500 / 570 Service Manual
© Copyright Polaris Inc.
FRONT BRAKE PADS
2 SEAT
PAD REMOVAL / DISASSEMBLY
1. Elevate and support front of machine.
WARNING
Use care when supporting vehicle so that it does not tip
or fall. Severe injury may occur if machine tips or falls.
2. Remove the front wheel. Loosen pad adjuster screw
q
2-3 turns.
3. Remove the two caliper bolts
w
and caliper from
mounting bracket.
4. Push caliper piston into caliper bore slowly using a
C-clamp or locking pliers with pads installed.
NOTICE
Brake fluid will be forced through compensating port
into master cylinder fluid reservoir when piston is
pushed back into caliper. Remove excess fluid from
reservoir as required.
5. Push upper pad retainer pin
e
inward and slip outer
brake pad past edge. Remove the pad.
BRAKE PAD INSPECTION
1. Check the brake pads for wear, damage, or
looseness.
2. Inspect the brake pad wear surface for excessive
wear.
MEASUREMENT
Brake Pad
.030″ (0.762 mm)
3. If any one pad is less than the service limit then all
pads should be replaced.
BRAKE SYSTEM
To Next Page
Loading...
Need help?
General
