3.62
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
28. Before installing the gear / stator housing, replace
the seals in the cover. Install a new water pump seal
(N) into the gear / stator housing. Use the Water
Pump Mechanical Seal Installer (PA-44995) to
properly install the seal to the correct depth in the
cover.
IMPORTANT: Due to seal design and
construction, seals MUST be installed DRY (no
lubricant) during assembly. Use of lubricants (oil,
soapy water, etc.) will not allow the seal to wear-
in and seal properly. Do not touch seal surface or
allow seal surface to come in contact with
contaminants during installation. Thoroughly
clean parts, tools and hands before installation.
NOTE: To remove the water pump seal, the gear/
stator housing must be removed. The water
pump seal cannot be removed or installed with
the gear/stator housing attached to the engine.
Shaft damage will occur.
NOTE: Install the water pump seal (N) with the
seal lip facing out (towards the crankcase). Use
of a hydraulic press is recommended for this
procedure.
29. Install a new crankshaft seal (P) into the gear/stator
housing cover. Use the Universal Driver Handle (PU-
45543) and the Main Seal Installer (PA-45483) to
seat the crankshaft seal into place.
NOTE: Install the crankshaft seal (P) with the
seal lip facing out (towards the crankcase).
ENGINE
To Next Page
Loading...
Need help?
General
