3
3.63
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.
30. Once crankshaft seal is installed into the gear / stator
housing cover, set the direction of the paper lip by
sliding the Main Crankshaft Seal Saver (PA-45658)
into the crankshaft seal from the rubber lipped side to
the paper lip side (Back to Front). Remove the tool.
31. Carefully install tapered end of the Crankshaft Seal
Protection Tool (PA-45658) through the paper side of
the crankshaft seal (back to front). Leave the seal
protector installed. Check the crankshaft seal lips to
verify they have not been rolled or damaged.
32. Before installing the gear/stator housing cover, install
the Water Pump Seal Saver (PA-45401) onto the
water pump shaft.
33. Apply Crankcase Sealant (PN 2871557) to the
outside edges of the crankcase halves (see arrows),
where the crankcases mate (see the following
photos). This helps to prevent coolant leakage.
ENGINE
To Next Page
Loading...
Need help?
General
