Pyronix Matrix 832 Installation Guide

Matrix 832 / 832+ / 424
Page 158 RINS428-5
12.12.13 Buzzer, LED & any Siren Connection to PGM on Matrix 832
NOTE: Terminal Connections to Matrix 832+ and Matrix 424 are the same as to a Matrix 832.
NVM Reset
Relay
17V~ +BAT- B+ B- BT GT NC C NO1/ PGM1 PGM2 PGM3 PGM4 KD Z1 Z2 Z3 Z4 COM COM +AUX- Z5 Z6 Z7 Z8 COM COM RING
TIP R-1 T-1
1
7
v
A
.
C
.
O
u
t
p
u
t
12V
BUZZER
-
-
+
+
IMPORTANT
Buzzer and LED may be
connected to any of the
programmable zones.
Siren must be connected to PGM1 500mA
Siren
1
K
A(+)
C(-)
LED
A(+)
C(-)
+AUX-
12.12.14 High-Powered Siren Connections for Matrix 832 / 832+ / 424
C1N01
30W Siren
15W Sire
n
+
-
-
+
Battery
Fuse
3A Anti -Surge
NOTE: When a high power siren is to be connected to a Matrix 832, Matrix 832+ or the relay version of
the Matrix 424, the PGM1 output (C1, NO1) should be used. This output uses a relay to switch up to a
maximum 3A DC current capacity, allowing the use of an additional battery to power the siren as
shown in the diagram above.

Pyronix Matrix 832 Specifications

General

Brand	Pyronix
Model	Matrix 832
Category	Control Panel
Language	English