4 – Managing Switches
Restoring the Factory Default Configuration
4-40 59097-02 B
S
4.11
Restoring the Factory Default Configuration
You can restore the switch and port configuration settings to the factory default
values. To restore the factory configuration on a switch, open the Switch menu
and select Restore Factory Defaults. Table 4-9 lists the factory default switch
configuration settings.
Restoring the switch to the factory default configuration does not restore the
account name and password settings. The most current port license will remain in
effect. To restore user accounts, you must select the Reset User Accounts to
Default option in the maintenance menu. Refer to “Recovering a Switch” in the
Installation Guide for your switch for information about maintenance mode and the
maintenance menu.
Table 4-9. Factory Default Configuration Settings
Setting Value
Symbolic Name SANbox
Administrative State Online
Domain ID 1
Domain ID Lock False
In-band Management True
Broadcast Support Enable
Resource Allocation Timeout (R_A_TOV) 10000 milliseconds
Interop Mode True
I/O Stream Guard Disabled
Device Scan Enabled True
Error Detect Timeout (E_D_TOV) 2000 milliseconds
SNMP Enabled True
SNMP Proxy True
IP Address 10.0.0.1
FDMI Enabled True
FDMI HBA Entry Level 1000
Subnet Mask Address 255.0.0.0
Gateway Address 10.0.0.254
To Next Page
Loading...
Need help?
General
