Qlogic SANbox 5600 Series User Manual

A – Command Line Interface
Set Port Command
A-80 59097-02 B
S
Set Port Command
Sets port state and speed for the specified port temporarily until the next switch
reset or new configuration activation. This command also clears port counters.
Authority Admin session except for the Clear keyword.
Syntax set port [port_number]
bypass [alpa]
clear
enable
speed [transmission_speed]
state [state]
Keywords [port_number]
Specifies the port. Ports are numbered beginning with 0.
bypass [alpa]
Sends a Loop Port Bypass (LPB) to a specific Arbitrated Loop Physical Address
(ALPA) or to all ALPAs on the arbitrated loop. [alpa] can be a specific ALPA or the
keyword ALL to choose all ALPAs.
clear
Clears the counters on the port. This keyword does not require an admin session.
enable
Sends a Loop Port Enable (LPE) to all ALPAs on the arbitrated loop.
speed [transmission_speed]
Specifies the transmission speed for the specified port. Choose one of the
following port speed values:
1Gb/s
One gigabit per second. This applies only to ports 0–15.
2Gb/s
Two gigabits per second. This applies only to ports 0–15.
4Gb/s
Four gigabits per second. This applies only to ports 0–15.
10Gb/s
Ten gigabits per second. This applies only to ports 16–19.

Qlogic SANbox 5600 Series Specifications

General

Model	SANbox 5600 Series
Form Factor	1U
Switch Type	Fibre Channel
Supported Protocols	Fibre Channel
Management Interface	Web-based GUI, CLI, SNMP
Port Speed	1 Gbps, 2 Gbps
Fabric Type	Fibre Channel
Hot Swappable	Yes
Redundancy	Dual power supplies, hot-swappable
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Humidity	10% to 90% non-condensing