A – Command Line Interface
CIMListener Command
A-14 59097-02 B
S
edit [listener_name]
Opens an editing session in which you can modify the CIM listener given by
[listener_name]. Refer to Table A-3 for a description of the CIM listener
configuration parameters.
Examples The following is an example of the CIMListener Create command:
SANbox xxxx (admin-cim) #> cimlistener create listener_1
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Name listener_1
Type (2=Permanent, 3=Transient) [Permanent ]
URL (IP address:port format) [10.0.0.1:5000]
Finished configuring attributes.
This configuration must be saved with the cim save command
before it can take effect, or to discard this configuration
use the cim cancel command.
To Next Page
Loading...
Need help?
General
