A – Command Line Interface
Config Command
59097-02 B A-17
A
Config Command
Manages the Fibre Channel configurations on a switch. For information about
setting the port and switch configurations, refer to the ”Set Config Command” on
page A-64.
Authority Admin session for all keywords except List
Syntax config
act
ivate [config_name]
backup
cancel
copy [config_source] [config_destination]
del
ete [config_name]
edit [config_name]
list
restore
save [config_name]
Keywords activate [config_name]
Activates the configuration given by [config_name]. If you omit [config_name], the
currently active configuration is used. Only one configuration can be active at a
time.
backup
Creates a file named configdata, which contains the system configuration
information. To download this file, open an FTP session, log in with account
name/password of “images” for both, and type “get configdata”. Refer to ”Backing
up and Restoring Switch Configurations” on page A-4.
cancel
Terminates the current configuration edit session without saving changes that
were made.
copy [config_source] [config_destination]
Copies the configuration given by [config_source] to the configuration given by
[config_destination]. The switch supports up to 10 configurations including the
default configuration.
del
ete [config_name]
Deletes the configuration given by [config_name] from the switch. You cannot
delete the default configuration (Default Config) nor the active configuration.
To Next Page
Loading...
Need help?
General
